Battery And Charging; Registration; Registering An Additional Handset - Motorola STARTAC S1201H User Manual

Table of Contents

Advertisement

4. If you are charging the batteries for the first time, place the handset on the charger to
charge for at least 24 hours continuously.
5. The display will show the handset name and number to indicate that it is registered to
the base.
IMPORTANT
Warning! Use only the approved rechargeable Ni-MH battery cells (2 x AAA Ni-MH 450mA
rechargeable batteries) supplied with your S12H
1.4

Battery and Charging

BATTERY LOW WARNING
If
icon flashes on the display and you hear a warning beep every minute during a
call, you will need to recharge the handset before you can use it again.
When charging,
BATTERY PERFORMANCE
In ideal conditions, fully charged batteries should give up to 10 hours talk time or up to 200
hours standby time on a single charge.
Note that new batteries do not reach their full capacity until they have been put to normal
use for several days.
To keep your batteries in the best condition, leave the handset off the base for a few hours
at a time.
Running the batteries right down at least once a week will help them last as long as
possible.
The charge capacity of rechargeable batteries will reduce with time as they wear out,
giving the handset less talk / standby time. Eventually they will need to be replaced.
After charging your handset for the first time, subsequent charging time is about 6–8 hours
a day. Batteries and handset may become warm during charging. This is normal.
1
All talk and standby times are approximate and depend on features selected and usage
pattern.
1.5

Registration

1.5.1

Registering an additional handset

You can register up to 5 handsets to your S12 main base to extend your phone system
without having to install extension sockets for each new phone.
You must register S12H to your S12 base before it can be used.
NOTE
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process.
Getting started
icon will scroll on the display.
1
5

Advertisement

Table of Contents
loading

Table of Contents