Advertisement
Quick Links
DW131/DW132/384028
5/2/02
Questions? See us in the World Wide Web at www.dewalt.com
INSTRUCTION MANUAL
GUIDE D'UTILISATION
MANUAL DE INSTRUCCIONES
DW131,DW132
1/2"(13mm) Spade Handle Drills
Perceuses de 13 mm (1/2 po) à poignée-bêche
Taladros 13 mm (1/2 ")Mango tipo espada
3:22 PM
Page 3
INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA
DE GARANTÍA. ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES
DE USAR EL PRODUCTO.
Advertisement
Related Manuals for DeWalt DW131
Summary of Contents for DeWalt DW131
- Page 1 DW131/DW132/384028 5/2/02 3:22 PM Page 3 Questions? See us in the World Wide Web at www.dewalt.com INSTRUCTION MANUAL INSTRUCTIVO DE OPERACIÓN, CENTROS DE SERVICIO Y PÓLIZA DE GARANTÍA. ADVERTENCIA: LÉASE ESTE INSTRUCTIVO ANTES GUIDE D'UTILISATION DE USAR EL PRODUCTO. MANUAL DE INSTRUCCIONES DW131,DW132 1/2"(13mm) Spade Handle Drills...
-
Page 2: Important Safety Instructions
DW131/DW132/384028 5/2/02 3:22 PM Page 4 IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS moving parts and should also be avoided. OR ANY D WALT TOOL, CALL US TOLL FREE AT: • USE SAFETY GLASSES. Also use face or dust mask if operation... -
Page 3: Grounding Instructions
DW131/DW132/384028 5/2/02 3:22 PM Page 1 Minimum Gage for Cord Sets • crystalline silica from bricks and cement and other masonry Volts Total Length of Cord in Feet products, and 120V 0-25 26-50 51-100 101-150 • arsenic and chromium from chemically-treated lumber (CCA). - Page 4 DW131/DW132/384028 5/2/02 3:22 PM Page 2 electric shock. The tool is equipped with a 3-conductor cord and 3- prong grounding type plug to fit the proper grounding type receptacle. FIG. 1 The green (or green and yellow) conductor in the cord is the grounding wire.
-
Page 5: Side Handle
DW131/DW132/384028 5/2/02 3:22 PM Page 3 Side Handle CAUTION: Always use and hold firmly the side handle or spade SIDE HANDLE handle. This is a high-torque drill- always hold it with both hands when operating. The side handle screws into the large hole in the top of the tool. -
Page 6: Chuck Removal
DW131/DW132/384028 5/2/02 3:22 PM Page 4 Chuck 2.Use sharp drill bits only. For WOOD, use twist drill bits, spade bits, power auger bits, or hole saws. For METAL, use high speed steel To insert bit, open chuck jaws by turning collar with fingers and twist drill bits or hole saws. - Page 7 DW131/DW132/384028 5/2/02 3:22 PM Page 5 Drilling in Masonry sizes up to the maximums shown in the table. MAXIMUM RECOMMENDED CAPACITIES Use carbide tipped masonry bits at low speeds. Keep even force on the drill but not so much that you crack the brittle materials. A Drill Capacity 1/2"...