Advertisement
DW131/DW132/384028
5/2/02
Minimum Gage for Cord Sets
Volts
120V
240V
Ampere Rating
More
Not more
Than
Than
0
-
6
6
-
10
10
-
12
12
-
16
• OUTDOOR USE EXTENSION CORDS. When tool is used
outdoors, use only extension cords intended for use outdoors and
so marked.
• STAY ALERT. Watch what you are doing. Use common sense.
Do not operate tool when you are tired.
• CHECK DAMAGED PARTS. Before further use of the tool, a
guard or other part that is damaged should be carefully checked
to determine that it will operate properly and perform its intended
function. Check for alignment of moving parts, binding of moving
parts, breakage of parts, mounting, and any other conditions that
may affect its operation. A guard or other part that is damaged
should be properly repaired or replaced by an authorized service
center unless otherwise indicated elsewhere in this instruction
manual. Have defective switches replaced by authorized service
center. Do not use tool if switch does not turn it on and off.
•
CAUTION: When drilling or driving into walls, floors or
wherever live electrical wires may be encountered, DO NOT
TOUCH ANY METAL PARTS OF THE TOOL! Hold the tool only by
insulated grasping surfaces to prevent electric shock if you drill or
drive into a live wire.
WARNING: Some dust created by power sanding, sawing, grinding,
drilling, and other construction activities contains chemicals known to
cause cancer, birth defects or other reproductive harm. Some
examples of these chemicals are:
• lead from lead-based paints,
3:22 PM
Page 1
Total Length of Cord in Feet
0-25
26-50
51-100
101-150
0-50
51-100
101-200 201-300
AWG
18
16
16
14
18
16
14
12
16
16
14
12
14
12
Not Recommended
• crystalline silica from bricks and cement and other masonry
products, and
• arsenic and chromium from chemically-treated lumber (CCA).
Your risk from these exposures varies, depending on how often you do
this type of work. To reduce your exposure to these chemicals: work in
a well ventilated area, and work with approved safety equipment, such
as those dust masks that are specially designed to filter out
microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing,
grinding, drilling, and other construction activities. Wear protective
clothing and wash exposed areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay on the skin may promote
absorption of harmful chemicals.
CAUTION: Wear appropriate hearing protection during use. Under
some conditions and duration of use, noise from this product may
contribute to hearing loss.
• The label on your tool may include the following symbols.
V ............................volts
A ............................amperes
Hz ..........................hertz
W ..........................watts
min ........................minutes
..........................alternating current
......................direct current
n o ..........................no load speed
.......................... Class II Construction
.../min ....................revolutions or reciprocation per minute
..........................earthing terminal
..........................safety alert symbol
Grounding Instructions
This tool should be grounded while in use to protect the operator from
1
Advertisement
