Advertisement
DW131/DW132/384028
5/2/02
Drilling in Masonry
Use carbide tipped masonry bits at low speeds. Keep even force on
the drill but not so much that you crack the brittle materials. A
smooth, even flow of dust indicates the proper drilling rate.
Lubrication
All bearings used are factory lubricated to last the life of the tool. All
needle bearings used receive their lubrication from the grease in the
gear case. Clean and relubricate gear case yearly or whenever
servicing requires the gear case to be removed. Use type and
quantity of grease shown on Parts Bulletin packed with your tool.
Gear case is removed by removing the three screws from the front
of the tool. If the chuck is too large to permit removal of the two top
screws, see instructions for chuck removal.
Motor Brushes
TURN OFF TOOL AND DISCONNECT FROM POWER SUPPLY.
To inspect brushes, unscrew the plastic brush inspection caps
(located in the sides of the motor housing) and the spring and brush
assemblies may be withdrawn from the tool. Keep brushes clean and
sliding freely in their guides. Carbon brushes have varying symbols
stamped into them, and if the brush is worn down to a point where the
symbol is not visible, they must be replaced. New brush assemblies
are available at authorized service centers.
Accessories
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D
WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286
E
call 1-800-433-9258.
CAUTION: The use of any other accessory not recommended
for use with this tool could be hazardous.
For safety in use, the following accessories should be used only in
3:22 PM
Page 5
sizes up to the maximums shown in the table.
MAXIMUM RECOMMENDED CAPACITIES
Drill Capacity
1/2"
RPM
0-450
Steel twist bit
1/2"
Auger
1 1/2"
Self-feed
3"
Spade
1 1/2"
Wood holesaw
5"
Steel holesaw
4"
ACCESSORY MUST BE RATED FOR USE AT SPEED EQUAL TO
OR HIGHER THAN NAMEPLATE RPM OF TOOL WITH WHICH IT
IS BEING USED.
Important
To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment (including brush inspection and replacement) should
be performed by authorized service centers or other qualified service
organizations, always using identical replacement parts.
Full Warranty
D
WALT heavy duty industrial tools are warranted for one year from
E
date of purchase. We will repair, without charge, any defects due to
faulty materials or workmanship. For warranty repair information,
call 1-800-4-D
WALT. This warranty does not apply to accessories or
E
damage caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and you may
have other rights which vary in certain states or provinces.
In addition to the warranty, D
or
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D
WALT heavy duty industrial tool, simply return it to the participating
E
seller within 30 days for a full refund. Please return the complete unit,
5
13mm
1/2"
13mm
0-1000
13mm
1/2"
13mm
38mm
1 1/2"
38mm
76mm
1 3/4"
45mm
38mm
1 1/2"
38mm
127mm
3"
76mm
102mm
1 1/2"
38mm
WALT tools are covered by our:
E
Advertisement
