GE JP362 Use And Care Manual page 27

Modular updraft cooktop
Hide thumbs Also See for JP362:
Table of Contents

Advertisement

Materials to Use
Part
Hot Soapy Water
Tub
Soap-Filled Scouring Pad
Hot Soapy Water
Reflector Pan
Soap-Filled Scouring Pad
Plastic Scouring Ball
Dishwasher Safe
Hot Soapy Water
Grease Collector Jar
Plastic Scouring Pad
Dishwasher Safe
Grill Grate
Hot Soapy Water
Plastic Scouring Ball
Dishwasher Safe
Hot Soapy Water
Griddle
. Plastic Scouring Bdl
Control Knobs
Control Panel
Soap and Water
Hot Soapy Water
. Hot Soapy Water
Aluminum
Stiff-Bristled Brush
Surface Unit
Drip Pans
Soap-Filled Scouring Pad
Dishwasher Safe
Hot Soapy Water
Chrome-Plated
Dishwasher Safe
None Required
Surface Unit Coils
and Grill Heating
Unit
Soap and Water
Solid Disk Elements
Cleansing Powder
and f~ed Sensi-
Soap-Filled Scouring Pad
(on models JP6~,
Cello Electrol@ Polish
Hot Soapy Water
Solid Disk Module
Soft Sponge
before touching or hanting.
General Directions
Wipe clean after each use. Make sure drain hole is not blocked. Use cotton swab
toothpick to clean drain hole.
Let grill cool. Remove grill heating unit and Iifi out Reflector Pan.
Reflector Pan may be cleaned using one of the methods at left.
Can be cleaned in dishwasher.
Scoop out grease with large spoon. Set jar in pan of warm water to loosen grease if
desired. Replace with any wide mouth canning jar. Do not use a mayonnaise jar
which could break when hot grease drips into it.
oven.
Do not clean in a self-cleaning
Can be cleaned in dishwasher.
Do not use abrasive cleaners.
DO N~ wash in dishwasher.
Pull off knobs. Wash gently but do not soak. Dry and return controls to cooktop
making sure to match flat area on the knob and shaft.
Wash with cloth dampened in soapy water. Rinse and polish with a dry
cloth. If knobs on the control panel are removed, do not allow water to run down
inside the surface of control panel while cleaning.
Wash, rinse, and then polish with a dry cloth. DO NOT USE
ammonia, acids, or commercial oven cleaners which may damage the finish.
Wipe dl drip pans after each cooking so spatter will not "bum on" next time you
cook. To remove "burned-on" spatters, use any or dl cleaning materials
lightly
mentioned. Rub
with scouring pad to prevent scratching of the surface.
Can be cleaned in the dishwasher.
Will discolor if cleaned in self-cleaning oven.
Wipe trim rings after cooking so spatters will not "burn on" the next time
Can be cleaned in the dishwasher.
DO N~ clean trim rings in a self-cleaning oven.
Spatters and spills burn away when the coils are heated. At the end of a meal,
remove all pans from the surface units and heat the soiled units at HIGH. Let the
soil burn off about a minute and switch the units to OFF. Avoid getting cleaning
materials on the coils. Wipe off any cleaning materials with a damp paper towel
before
heating the surface unit.
DO N~ handle the unit before completely cooled.
DO NOT clean plug-in units in a self-clean oven.
DO NOT immerse plug-in units in any kind of liquid or clean in dishwasher.
The solid disk elements should be washed with a damp cloth and then dried. Finish
by wiping over lighfly with cooking oil when cool. Clean very dirty solid disk
elements with a little cleaning powder or a scouring pad. Do not scour the center
sensing device on the Sensi-Temp W" element. The matte black surface can be
maintained by treating it periodically with the Cello Electrol@ polish. It is available
from your GE supplier. To use the finish, use the applicator to apply a very thin
coating of the polish to the entire element surface. ~rn the element on high for
several minutes to bake the polish to the element. When the element is cool, rub
Clean the brushed chrome finish and the staidess steel trim ring that surrounds the
solid disk element by following the directions below.
For light soil, wash and rinse with soapy water and then polish with a dry cloth.
For heavy soil, spritie baking soda on soiled area. Cover with a moist cloth or
paper towel and allow to set for at least 30 minutes. Then wipe up the baking soda,
rinse with a damp cloth and polish with a dry cloth. DO N~ USE steel wool or
abrasives on the solid disk module or elements.
or
steel wool, abrasives,

Advertisement

Table of Contents
loading

This manual is also suitable for:

Jp673Jp671

Table of Contents