Table of Contents
Advertisement
Before using for the first time
Programming the water hardness
level
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in and, whilst holding it in, switch
the dishwasher on using the
button.
Keep the programme selector button
pressed in for at least 4 seconds
until the lower right-hand programme
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the Turbo button twice.
The Turbo indicator light will flash
rapidly twice at intervals.
20
The value which has been set for the
water hardness is shown as a figure
after in the display (see chart).
will start flashing in the display.
This is the factory default setting of
1 °d.
Use the programme selector button
to select the value which equates
to your water hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
Hide quick links:
Advertisement
Table of Contents
