Packet Data (Gprs) Settings; Wlan Settings; Advanced Wlan Settings - Nokia E51 User Manual

To create a new access point, select
access point or select an existing access point from the
list and then Options
the access point as a basis for the new one.

Packet data (GPRS) settings

Select Menu Tools
>
Packet data.
Your device supports packet data connections, such as
GPRS in the GSM network. When you are using your
device in GSM and UMTS networks, it is possible to have
multiple data connections active at the same time;
access points can share a data connection, and data
connections remain active, for example, during voice
calls. See "Connection manager," p. 100.
To define the packet data settings, select
connection and select
device to the packet data network when you switch the
device on in a supported network, or
establish a packet data connection only when an
application or action requires it. Select
and enter the access point name provided by your
service provider to use the device as a packet data
modem to your computer.
These settings affect all access points for packet data
connections.

WLAN settings

Select Menu Tools
>
118 Wireless LAN.
Options
>
Duplicate access point
>
Settings Connection
> >
Packet data
When available to register the
When needed
Access point
Settings Connection
> >
New To have an indicator displayed when there is a WLAN
available in your current location, select
to use availability > Yes.
To select the interval for your device to scan for
available WLANs and update the indicator, select
for networks. This setting is not available unless you
select Show WLAN availability
>

Advanced WLAN settings

Select Options
WLAN settings are normally defined automatically, and
changing them is not recommended.
To edit the settings manually, select
configuration
Long retry limit
•
transmission attempts if the device does not receive
a receiving acknowledgement signal from the
network.
to
Short retry limit
•
transmission attempts if the device does not receive
a clear-to-send signal from the network.
RTS threshold
•
which the WLAN access point device issues a request
to send before sending the packet.
TX power level
•
device when sending data.
Radio measurements
•
radio measurements.
Power saving
•
power saving mechanism to save the power in the
>
device battery. Using the power saving mechanism
> Yes.
Advanced settings. The advanced
>
Automatic
> Disabled, and define the following:
— Enter the maximum number of
— Enter the maximum number of
— Select the data packet size at
— Select the power level of your
— Enable or disable the
— Select whether to use the WLAN
Show WLAN
Scan