Download Print this page

Panasonic ES8163 Operating Instructions Manual page 4

Wet/dry rechargeable shaver

Advertisement

B424164_ES8163_AU_Tori
Before use
This Wet/Dry shaver can be used for
wet shaving with shaving lather or for
dry shaving. You can use this water-
tight shaver in the shower and clean
it in water. The following is the sym-
bol of Wet shaver. The symbol means
that hand-held part may be used in a
bath or shower.
Treat yourself to wet lather shaves
for at least three weeks and notice
the difference.Your Panasonic Wet/
Dry shaver requires a little time to get
used to because your skin and beard
need about a mosnth to adjust to any
new shaving method.
Parts identification
(see fig. 1)
A Protective cap
B System outer foil
C Inner blades
D System outer foil release
buttons
E Pivot action selector
F LCD display [ES8163]
LED display [ES8162]
削除
[ES8161]
G On/Off switch
H Finger rest
I Trimmer
J Trimmer handle
K Adaptor
L Power cord
M Charging stand
N Cleaning brush
O Soft case
P Oil
READ ALL INSTRUCTIONS BE-
FORE USE.
Charging
Connect the power cord to the
shaver, and plug the adaptor to an
AC outlet. (see fig. 1 (A))
The shaver will be adjusted automati-
cally to voltages between 100-240V
AC.
In some areas, a special plug adap-
tor may be required.
• When charging the shaver for the
first time or when it has not been in
use for more than 6 months, the
plug syambol and backlight of LCD
display may not illuminate for a few
minutes after operation. These
lights will eventually illuminate if
kept connected.
Adequate ambient temperature for
charging is between 15 to 35 °C.
• If it is far below or over the appro-
priate temperature, the charging
time may extend, or the adaptor
may not function.
• In particular, low temperature may
shorten the life span of the recharge-
able battery. In this case, the back-
light of LCD display blinks twice in 1
second.
6
06-11-13
When the shaver is being charged,
the backlight of LCD display turns
on, and the plug symbol appears
(see fig. 2 (A)).
It shows the remaining battery
capacity from 0% to 100%, in 10%
increments.
When the charging is completed, it
will indicate "100%" and the back-
light of LCD display will flash once
in about 1 second. It will flash once
in about 2 seconds for 10 minutes
after charging is completed (see
fig. 2 (B)).
You can fully charge the shaver in
1 hour if the LCD display shows
10% and lower.
The plug symbol blinks in the LCD
display when the remaining battery
capacity is 10% and less.
The unit can be used once or twice
more after the LCD display starts to
show 10%. (Differs depending on
the use situation.)
A full charge will supply enough
power for approx. 14 shaves (3
minutes per shave for a normal
beard).
Before travelling, charge it fully for
1 hour if you will not be taking the
adaptor with you.
In case your shaver is without
charge, you may quick charge it for
1 shave in about 5 minutes.
Charge with charging
stand
(see fig. 1 (B))
To charge with the charging stand,
connect the power cord to the
charging stand. Place the shaver
into the stand, and plug the adaptor
to the AC outlet.
You can always store your shaver
in the charging stand to maintain
full battery capacity. This shaver
cannot be overcharged.
Using your shaver
Caution – The system outer foil is
very thin and can be damaged if
handled improperly. Before each
use, always check the foil for dam-
age. To avoid personal injury, do
not use if the foil or other parts of
the shaving head is damaged.
Disconnect the power cord from the
shaver, and push the On/Off switch
to turn the shaver on.
If you push and hold the On/Off
switch for more than 2 seconds, it
will activate the turbo mode for
"sonic" vibration cleaning.
(see "Cleaning your shaver")
Caution:
Shaving with "sonic" vibration may
damage your skin. Please turn it
off and on again to deactivate the
turbo mode.
Do not place fingers on the On/Off
switch during use.
This may cause the shaver to stop
during use or change it to the
"sonic" vibration cleaning mode.
Place your finger on the finger rest
during use.
Hold the shaver at a right angle (90°)
to your skin (see fig. 3). Start out
shaving by applying gentle pressure
to your face. Stretch your skin with
7

Advertisement

loading