Technical Data; Declaration Of Conformity; Battery Charging - Bosch GSA 24 VE Professional Original Instructions Manual

18 | English

Technical Data

Sabre saw
Article number
Rated voltage
Stroke rate at no load n
Tool holder
Stroke rate control
Stroke
Weight according to
EPTA-Procedure 01/2003
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Noise/Vibration Information
Measured values determined according to
EN 60745.
Typically the A-weighted noise levels of the prod-
uct are: Sound pressure level 87 dB(A); Sound
power level 98 dB(A). Uncertainty K =3 dB.
Wear hearing protection!
Vibration total values (triax vector sum) deter-
mined according to EN 60745:
Cutting wood: Vibration emission value
2
a =19 m/s , Uncertainty K=2.0 m/s
h
The vibration emission level given in this informa-
tion sheet has been measured in accordance with
a standardised test given in EN 60745 and may be
used to compare one tool with another. It may be
used for a preliminary assessment of exposure.
The declared vibration emission level represents
the main applications of the tool. However if the
tool is used for different applications, with different
accessories or poorly maintained, the vibration
emission may differ. This may significantly increase
the exposure level over the total working period.
An estimation of the level of exposure to vibra-
tion should also take into account the times
when the tool is switched off or when it is run-
ning but not actually doing the job. This may sig-
nificantly reduce the exposure level over the to-
tal working period.
1 609 929 N69 | (28.1.08)
GSA 24 VE
Professional
0 601 645 2..
V=
0 – 2300
spm
0
SDS
mm 19/32
kg 3.9
2
.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories, keep
the hands warm, organisation of work patterns.

Declaration of Conformity

24
We declare under our sole responsibility that
the product described under "Technical Data" is
in conformity with the following standards or
standardization documents: EN 60745 accord-
ing to the provisions of the directives
2004/108/EC, 98/37/EC (until Dec. 28, 2009),
2006/42/EC (from Dec. 29, 2009 on).
Technical file at:
Robert Bosch GmbH, PT/ESC,
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
Engineering
09.01.2008, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Assembly

Battery Charging

A battery that is new or has not been used for a
longer period does not develop its full capacity
until after approx. 5 charging/discharging cy-
cles.
To remove the battery 10 press the unlocking
buttons 9 and pull out the battery downwards.
Do not exert any force.
The battery is equipped with a NTC temperature
control which allows charging only within a tem-
perature range of between 0 °C and 45 °C. A
long battery service life is achieved in this man-
ner.
A significantly reduced working period after
charging indicates that the battery is used and
must be replaced.
Observe the notes for disposal.
Dr. Eckerhard Strötgen
Head of Product
Certification
Bosch Power Tools