Aichi 446-8502 Japan declares that this product in accordance with Council Directives, 73/23/EEC (Serial No. : series production) and 89/336/EEC. manufactured by Makita Corporation in Japan is in compliance with the following standards or standard- Yasuhiko Kanzaki CE 94 ized documents,...
Do not discard batteries into garbage ❏ Charging ❏ can or the like. ❏ Charging complete Note: The recycling method may differ from country to country, or state (province) to state (province). Consult with your nearest Makita Authorized Service Center or Distributor.
ENGLISH Explanation of general view Button 10 A side 19 Drill marking Battery cartridge 11 B side 20 Pointer Charging light 12 Clockwise 21 Screw Fast charger 13 Counterclockwise 22 Set plate Tighten 14 Low speed 23 Limit mark Sleeve 15 High speed 24 Screwdriver Ring...
Page 6
Do not store the tool and battery cartridge in CAUTION — To reduce risk of injury, charge only locations where the temperature may reach or MAKITA type rechargeable batteries. Other types exceed 50°C (122°F). of batteries may burst causing personal injury Do not incinerate the battery cartridge even if it and damage.
Page 7
Approx. 70 min. CAUTION: • The fast charger is for charging Makita battery cartridge. Never use it for other purposes or for other manufacturer’s batteries. • When you charge a new battery cartridge or a battery cartridge which has not been used for a long period of time, it may not accept a full charge.
(mm) replaced at the same time. 2.0 – 2.2 To maintain product safety and reliability, repairs, mainte- nance or adjustment should be carried out by Makita 2.2 – 2.5 Authorized Service Center. 2.5 – 2.8 2.9 – 3.2 3.1 –...
Page 9
ACCESSORIES CAUTION: These accessories or attachments are recommended for use with your Makitaauthorise tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attach- ments should be used only in the proper and intended manner. Bit No.