Operation - Polaris Frontier Classic Owner's Manual

OPERATION

Starting the Engine
Before starting the engine, always refer to all safety warnings
pertaining to snowmobile operation. Never start your snowmobile
without checking all components to be sure of proper operation.
See Pre-Ride Inspection section beginning on page 53.
Do not depress the throttle until the engine starts.
1. Pull the kill switch (shut-off switch) up to the RUN position.
2. Turn the key to START and crank the engine. NOTE: There will
be a half second delay before the starter engages to allow the ACS
system to "wake up."
3. After the engine starts, release the key to the ON position.
NOTE: If the engine doesn't start on the first attempt when the air
temperature is below -5° F. (-20° C.), wait 15 seconds for the
electrical system to recover, then attempt to start again.
NOTE: The Frontier is equipped with a recoil for emergency starting.
See page 67.
58
WARNING