Toyota corolla 2004 Owner's Manual page 191

—Loosening wheel nuts
4. Loosen all the wheel nuts.
Always loosen the wheel nuts before
raising the vehicle.
Turn the wheel nuts counterclockwise
to loosen. To get maximum leverage,
fit the wrench to the nut so that the
handle is on the right side, as shown
above. Grab the wrench near the end
of the handle and pull up on the han-
dle. Be careful that the wrench does
not slip off the nut.
Do not remove the nuts yet—just un-
screw them about one−half turn.
'04 Corolla_U (L/O 0306)
CAUTION
Never use oil or grease on the
bolts or nuts. The nuts may loose
and the wheels may fall off,
which could cause a serious ac-
cident.
—Positioning the jack
5. Position the jack at the correct
jack point as shown.
Make sure the jack is positioned on
a level and solid place.
2004 COROLLA from Oct. '03 Prod. (OM12859U)
191