Using Your Removable Handheld Steamer With Grout Scrubber Brush; Care Of Your Steam Mop - Shark S3901NZ Owner's Manual

Using Your Removable Handheld Steamer with Grout Scrubber Brush

Cleaning Tip: the Grout Scrubber Brush is designed for removing stubborn messes in hard-to-reach nooks, corners
and in grout where focused scrubbing power may be needed. The Grout Scrubber Brush can loosen and dislodge
compact dirt often found in corners and tight places where traditional methods and cleaning tools tend to push dirt
into, making it difficult to reach and clean. Scrub with the Grout Scrubber Brush and wipe clean with a cleaning cloth.
fig. 33
1
Attach the Grout Scrubber Brush by snapping into
the handle of the Accessory Hose. (fig. 33)
2 Select either DUST, MOP or SCRUB mode by
pressing the ON/STEAM SETTING button and wait
until the selected setting indicator light turns solid
blue. Hold down the steam trigger to start steaming.
(fig. 34)
19 CUSTOMER CARE - NZ: 0800 002 999
fig. 34
3
To remove the Grout Scrubber Brush, press and hold
down the Accessory release button. Then slide out
the Grout Scrubber Brush.
CAUTION: Do not press steam trigger while
attaching or removing the Grout Scrubber Brush.

Care of Your Steam Mop

fig. 35 fig. 37
AFTER USE AND STORAGE
1
When you have finished using the Handheld Steamer,
reattach it to the mop by first placing the bottom of
the Handheld Steamer into the cradle of the mop
housing. (fig. 35)
2
Then slide the top end of the Handheld Steamer into
the mop housing and snap into place.
NOTE: Make sure all attachments are removed
before reuniting the Handheld Steamer with the
Steam Mop.
3 If you are also done mopping, press the ON/STEAM
SETTING button until the LED light turns flashing
blue. This stops the unit from steaming. Unplug
the cord from the outlet and place the mop into the
upright position. Let the unit cool for 2-3 minutes.
Remove the cleaning pocket by releasing the quick
fasteners and using the lavender loop on the side of
the pocket, avoiding contact with the hot pocket or
dirt. (fig. 36)
fig. 36
fig. 38
4
Empty the water tank before storage. Remove the
water tank cap and empty the tank over a sink.
Replace the water cap. (fig. 37)
5
To store the Shark Lift-Away Pro Steam Pocket
® ™
Mop hanging up, first remove the head (after it has
cooled and the steam has been released) then hang
on a large hook. (fig. 38)
6 Place the Direct Steam Nozzle on the storage clip for
easy accessibility.
CUSTOMER CARE - AU: 1800 890 840
®
20