Table of Contents
Advertisement
4) Click Broadband (PPPoE).
5) Enter the User name and Password given by your ISP, and type a Connection name to
identify your connection, and then click Connect.
T2. How do I restore my Terminal to its factory default settings?
Once the Terminal is reset, the current settings will be lost and you will need to reconfigure it. We
strongly suggest you back up the current settings before resetting the Terminal.
With the Terminal powered on, press and hold the RESET button on the rear panel of the Terminal
until all LEDs turn back on momentarily, then release the button.
T3. What can I do if I forget my Terminal's password?
Reset the Terminal first and then use the default username and password: admin/admin.
T4. How do I change my computer's setting to obtain an IP address automatically?
For Mac OS X
1) Click the Apple icon on the upper-left corner of the taskbar.
2) Go to System Preferences > Network.
3) Select Ethernet in the left panel.
4) Under Configure IPv4, select Using DHCP.
5) Click Apply.
For Windows 7/8/8.1
1) Right-click the Network icon (e.g.
Sharing Center > Change adapter settings.
2) Right-click the wired network connection (Local Area Connection or Ethernet by default) and
select Properties.
3) Double-click Internet Protocol Version 4 (TCP/IPv4).
4) Select both Obtain an IP address automatically and Obtain DNS server address
automatically, then click OK.
5) Click OK again to save your configuration.
For Windows XP
1) Right-click the Network icon (e.g.
Connections.
2) Right-click the wired network connection (Local Area Connection by default) and select
Properties.
3) Double-click Internet Protocol (TCP/IP).
4) Select both Obtain an IP address automatically and Obtain DNS server address
automatically, then click OK.
5) Click OK again to save your configuration.
TX-6610
1-Port Gigabit GPON Terminal User Guide
) on the system tray and select Open Network and
) on the system tray and select Open Network
21
Advertisement
Table of Contents
