Data Or Fax Calls; Call Summary; Ringing Tone For No Caller Id; Data Transfer - Nokia 6155 User Manual

9243644_6155_en_au.fm Page 54 Wednesday, December 28, 2005 11:28 AM
S e t t i n g s
1. In standby mode, select
Settings > Call > Calling
2. Enter your lock code, and select OK.
See "Change lock code", p. 61.
3. Select your desired calling card.
4. Press the end key to return to
standby mode; then enter the
phone number, including any prefix
(such as 0 or 1) that your calling
card may require when you make a
calling card call. See your calling
card for instructions
5. Press and hold the call key for a few
seconds until Card call
6. When you hear the tone or system
message, select OK.

Data or fax calls

Data and fax calling is a network
service. See "Network services", p. viii.
If your network operator supports this
feature, you can set up the device to
send or receive data and fax calls with
a terminal, such as a PDA or PC,
connected.
For better performance during data
calls, place the device on a stationary
surface. Do not move the device or
hold it in your hand during a data call.
For more information on connectivity,
refer to the PC/PDA Connectivity Guide
which can be downloaded from the
Nokia website at www.nokia-asia.com.
54
Menu > 1. In standby mode, select
card. Settings > Call
Incoming data/fax call
the following options:
Normal—The device receives
incoming calls as usual.
Data calls only—The device receives
only data calls.
Fax calls only—The device receives
only fax calls.
2. When finished with receiving the
fax or data call, repeat steps 1 and
2, and select Normal.
is displayed.

Data transfer

You can view the transmission speed
when sending or receiving data and
fax calls. In standby mode, select
Menu > Settings
calls > Data rate display
or Off.

Call summary

Your device can display the time spent
on a call when you hang up. In standby
mode, select Menu
Call summary > On

Ringing tone for no caller ID

You can select a different ringing tone
for calls received with no caller ID. In
standby mode, select
Settings > Call >
caller ID > On or Off.
Menu >
> Data/fax calls >
and one of
> Call > Data/fax
> Graphic
> Settings > Call >
or Off.
Menu >
Ringing tone for no