Operation - Makita 6823 Instruction Manual

Reversing switch action
1
A
B
002635
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the position (A side) for clockwise rotation or
the position (B side) for counterclockwise rotation.
CAUTION:
Always check the direction of rotation before
•

operation.

Use the reversing switch only after the tool comes
•
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
Hook
The hook is convenient for temporarily hanging the tool.
When using the hook, pull it out in A direction and then
push it in B direction to secure in place.
When not using the hook, return it back to its initial
position by following the above procedures in reverse.
A
002644
002645
1. Reversing
switch lever
1. Hook
1
B
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before carrying out any work on the
tool.
Installing or removing the bit
To remove the bit, first pull the locator out of the locking
sleeve. Then grasp the bit with a pair of pliers and pull
the bit out of the magnetic bit holder. Sometimes, it helps
to wiggle the bit with the pliers as you pull.
1
002653
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the locking sleeve.
2 3
002661
OPERATION
002673
Fit the screw on the point of the bit and place the point of
the screw on the surface of the workpiece to be fastened.
Apply pressure to the tool and start it. Withdraw the tool
as soon as the clutch cuts in. Then release the switch
trigger.
5
1. Locator
2. Locking sleeve
2
1. Locator
1
2. Bit
3. Magnetic bit
holder