Table of Contents
Advertisement
Installing the appliance
Screw lower fixing bracket with
screws loosely into the bottom of
the appliance.
Push the appliance into the building-
in niche:
– until the upper fixing bracket
touches the front edge of the furni‐
ture side wall.
– until the front edge of lower left-hand
fixing bracket and the lower right-
hand fixing bracket is flush with the
front edge of the base of the housing
unit.
This will create a gap all round of 42
mm to the front edges of the housing
unit side walls.
Installing the appliance
On furniture with door fittings (e.g.
stubs, seals etc.) the dimension of
these must be taken into account
when making sure there is a gap all
round of 42 mm.
Pull the appliance forwards by the
appropriate dimension.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture
doors.
If the all round gap of 42 mm is not
maintained between the appliance
housing and the front edge of the
housing unit side walls, the door may
not shut properly.
This can cause ice to build up, con‐
densate to accumulate and lead to
faults in the appliance. These can all
lead to increased energy consump‐
tion.
59
Hide quick links:
Advertisement
Table of Contents
