Computer Instruction - Advantage 16116488-1 Owner's Manual

FUNCTION BUTTON
MODE:
FUNCTION:
Scan:
Time:
Speed:
Distance:
Calorie:
Finger pulse:
NOTE
1. Monitor requires two "AA" batteries
2. The monitor will turn on automatically by pressing any key or when you start pedaling.
3. The monitor will turn off automatically if no signal is detected for four minutes.
4. If monitor is illegible or partial segments appear, remove batteries and wait 15 seconds to re-install.
5. Rechargeable batteries are not recommended.
Customer Service 1-888-707-1880
Or email us at customerservice@dyaco.ca

COMPUTER INSTRUCTION

Press to select functions between: scan, time, speed, distance, calories and pulse.
Press and hold for 3 seconds to rest all values to zero.
Displays each function in sequence every 4 seconds. The display loop is time,
speed, distance, calories and pulse.
Displays your elapsed workout time up to 99:59
Displays the current speed up to 99.9 km.
Displays the cumulative distance traveled during your workout up to 99.9KM
Displays the cumulative calories burned at any given time during your workout up
to 999 kcal.
Note: This is a rough guide used for comparison of different exercise sessions,
which cannot be used for medical purposes.
The monitor will display the user's current heart rate in beats per minute during the
workout while in heart rate mode.
Using your finger or thumb press the sensor found below the heart logo at the
bottom of the computer.
8 Dyaco Canada Inc. © 2013