Table of Contents
Advertisement
LDK-24 WOTS
GDC-345H Factory Mode Manual
3.1.
Entering
1 > H S
S e t t i n g
2
K e y L o c k
F A C .
C O D E
1 > V e r s i o n
2
R e s e t
button until the cursor(>) goes to where you want to select. And press OK button.
Then, it enters into submenu you want.
3.2.
Exiting
To exit from 'LGGAP mode' or any submenu, press 'C/R' button repeatedly until ' Idle
State' is displayed. Or, press PWR button more than 1 second.
3.3.
Version
P S T
2 . 0 D
2 0 0 4 . 0 6 . 1 9
3.4.
Reset
C L E A R
E E P R O M
?
It can be possible to enter into ' LGGAP mode'
through the main menu. Please, for detail for
main menu, refer to GDC-345H User Guide.
Press MENU(UP(
) or DOWN(
main menu will be displayed as left.
Press
button to enter into 'LGGAP Mode' .
When LCD is displayed like left, input password to
enter into LGGAP mode.
The FAC. CODE is ' 54427' .
After input '54427' , press OK button.
In case of successfully entering into 'LGGAP
mode' , LCD is displayed as left. If the password is
not exact, LCD returns to main menu.
You can select a submenu alternative of direct
selection or scroll selection. When you use direct
selection, press directly number button refer to
above menu tree. When you use scroll selection,
press repeatedly MENU(UP(
This submenu shows you the software version of
GDC-345H and creation date.
The version and date may different from that of
left.
This submenu enables you to clear the EEPROM of
GDC-345H. If you want initialize all data of
EEPROM, press OK button. Else press C/R button
to cancel.
If once clearing is started, you cannot abort. And
all data will be deleted except data related to
hardware control parameter. Therefore, you have
7/10
ISSUE 1.0
)) button, then
) or DOWN(
))
Advertisement
Table of Contents
