Packet Data; Data Transfer - Nokia 5300 User Manual

S e t t i n g s

Packet data

General packet radio service (GPRS) is a network service that allows mobile
phones to send and receive data over an Internet protocol (IP)-based network.
To define how to use the service, select
data > Packet data conn. and from the following options:
When needed — to set the packet data connection to established when an
application needs it. The connection will be closed when the application is
terminated.
Always online — to set the phone to automatically connect to a packet data
network when you switch the phone on
Modem settings
You can connect the phone using Bluetooth wireless technology or USB data
cable connection to a compatible PC and use the phone as a modem to enable
GPRS connectivity from the PC.
To define the settings for connections from your PC, select
Connectivity > Packet data > Packet data settings
activate the access point you want to use. Select
data acc. pt., enter a name to change the access point settings, and select OK.
Select Packet data acc. pt., enter the access point name (APN) to establish a
connection to an network, and select OK.
You can also set the EGPRS dial-up service settings (access point name) on your
PC using the Nokia Modem Options software. See "Nokia PC Suite," p. 76. If you
have set the settings both on your PC and on your phone, the PC settings are
used.

Data transfer

Synchronize your calendar, contacts data, and notes with another compatible
device (for example, a mobile phone), a compatible PC, or a remote Internet
server (network service dependency).
Your phone allows data transfer with a compatible PC or another compatible
device when using the phone without a SIM card.
Transfer contact list
To copy or synchronize data from your phone, the name of the device and the
settings must be in the list of transfer contacts. If you receive data from another
device (for example, a compatible mobile phone), the corresponding transfer
44
Menu > Settings > Connectivity
Menu > Settings
> Active access point, and
Edit active access pt. >
> Packet
>
Packet