Troubleshooting - Black & Decker HH2455 Instruction Manual

Figure F depicts the rear handle in 90 ° left (fl), 0 ° (f2) and 90 ° right (f3) positions.
I/:tlL'AIL'AII_Id II_Iil]_[_II[l_
1. EXTENSION CORD - (Figure G) Always keep
extension cord behind trimmer and away from the
trimming operation. Never drape it over a hedge being
trimmed. If you cut or damage the cord, unplug it at the
electrical outlet immediately, before inspecting or
repairing cord.
2. WORKING POSITION - Maintain proper footing and
balance and do not overreach. Wear safety goggles,
non-skid footwear and rubber gloves when trimming.
Hold the tool firmly in both hands and turn the tool ON.
Always hold the trimmer, as shown in figure G, with
one hand on the switch handle and one hand on the
bail handle. Never hold the tool by the blade guard.
3. TRIMMING NEW GROWTH - (Figure H) -A wide,
sweeping motion, feeding the blade teeth through the
twigs is most effective. A slight downward tilt of the
blade, in the direction of motion gives the best cutting.
Z_CAUTION: Do not use the trimmer for cutting stems
greater than 3/4 in. (19mm). Use the trimmer only for
cutting normal shrubbery found around houses and
buildings.
4. LEVEL HEDGES (Figure I) - To obtain exceptionally
level hedges, a piece of string can be stretched along
the length of the hedge as a guide.
5. SIDE-TRIMMING HEDGES (Figure J) - Begin at the bottom
and sweep up.
Z_WARNING" TO GUARD AGAINST INJURY, OBSERVE THE
FOLLOWING:
READ INSTRUCTION MANUAL BEFORE USING, SAVE
INSTRUCTION MANUAL.
CHECK THE HEDGE FOR FOREIGN OBJECTS SUCH AS
WIRE OR FENCES BEFORE EACH USE.
KEEP HANDS AWAY FROM BLADES.
KEEP HANDS ON HANDLES. DON'T OVERREACH.
Z_CAUTION: - BLADE COASTS AFTER TURN OFF.
DO NOT USE UNDER WET CONDITIONS.
DO NOT USE WITH DAMAGED EXTENSION CORD.
DO NOT UNPLUG OR STORE WITH SWITCH LOCKED ON.
DANGER: KEEP HANDS AWAY FROM BLADES.
z_ CAUTION: BLADE COASTS AFTER TURN OFF.
Problem
• Unit will not start.
TROUBLESHOOTING
Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
Possible Solution
• Plug tool into a working
outlet.
• Replace circuit fuse.
(If the product repeatedly
causes the circuit fuse to
blow, discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Reset circuit breaker.
(If the product repeatedly
causes the circuit
breaker to trip,
discontinue use
immediately and have it
serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch
replaced at Black
& Decker Service Center
or Authorized Servicer
For assistance with your product, visit our website www, blackanddecker, com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
6 7