Care Of Your Steam Mop - Sharp S3455UKE Owner's Manual

Care of Your Steam Mop

fig. 13
fig. 14
AFTER USE AND STORAGE
1 When you have finished using the steam mop, press
the STEAM CONTROL button until the LED light turns
flashing BLUE. This stops the unit from steaming.
Unplug the cord from the outlet and place the mop into
the upright position. Let the unit cool for 2-3 minutes.
Remove the cleaning pocket by releasing the quick
fasteners and using the lavender loop on the side of
the pocket, avoiding contact with the hot pocket or
dirt. (fig. 13)
8 Freephone: 0800 862 0453
fig. 15
2 Empty the water tank before storage. Open the water
tank door and empty the tank over a sink. Close the
water cap. (fig. 14)
3
To store the Shark Professional SLIM Steam
®
Pocket ® Mop hanging up, first remove the head (after
it has cooled and the steam has been released) then
hang on a large hook. (fig. 15)
fig. 16
fig. 17
CARE OF YOUR CLEANING POCKET
1
We recommend washing your cleaning pocket
separately from other fabrics to avoid picking
up lint. Only use liquid detergent (no powder
detergent). Do not use any fabric softeners or
bleach. For optimal cleaning performance pockets
may need to be washed up to (3) three times. Line
dry. Do not tumble dry. (fig. 16)
2
If there are loose threads on the cleaning pocket
carefully cut the thread with scissors. Do not pull on
them or cut at the base. (fig. 17)
ORDERING REPLACEMENT PARTS
To order additional parts and accessories, feel free to
contact us at:
Shark Customer Services
15 Mariner Court
Calder Park
Wakefield
WF4 3FL
Freephone 0800 862 0453
www.sharkclean.eu
fig. 18
DECALCIFYING YOUR STEAM MOP
Calcium and mineral deposits can build up and impact
the performance of your steam mop over time.
CLEANING THE NOZZLE
Your steam mop should not normally require
cleaning, however, should you notice a decrease in
the steam output, it may be necessary to remove
mineral deposits built up around the nozzle.
1
Unplug the steam mop from the electrical outlet.
2 Use a small diameter stiff metal wire, such as a
straightened metal paperclip, and carefully insert the
end of the wire into the nozzle orifice. (fig. 18)
3
Move the wire back and forth several times to
remove any deposits.
4
Plug the steam mop in to the power outlet and test
steam output.
PART PART NO.
1 Cleaning Pockets
XTSM200UK
2 Triangle Pads STT3901UKJR
3 Carpet Glider XCG3501UK
www.sharkclean.eu/uk 9