Using Your Steam Mop - Sharp S3455UKE Owner's Manual

Getting Started - cont'd
fig. 2
fig. 3
2 Select either the All-Purpose Mop Head or the
Triangle Mop Head and accompanying cleaning pad.
Use the loop on the side of the cleaning pad to slide
the mop head into the pad pocket. Then secure the
quick fasteners on the top of the pocket to lock in
place. (fig. 2)
3 Snap the mop head into the base to secure it. (fig. 3)
4 Open the water tank door. (fig. 4)
Use the filling flask and pour water into the tank. Do
not overfill. Press the water tank door firmly to close.
(fig. 5)
4 Freephone: 0800 862 0453
fig. 4
fig. 5
IMPORTANT: Do not use on unsealed wood or
unglazed ceramic floors. On surfaces that have
been treated with wax or some no wax floors, the
sheen may be removed by the heat and steam
action. It is always recommended to test an isolated
area of the surface to be cleaned before proceeding.
We recommend that you check the use and care
instructions from the floor manufacturer.

Using Your Steam Mop

IMPORTANT: Do not use the mop without attaching
a cleaning pocket and adding water to the tank first.
When you are using the mop for the first time, it
might take longer than the normal 30 seconds to
start steaming.
fig. 6
IMPORTANT: Sweep or vacuum your floors prior to
cleaning with your Steam Mop.
fig. 7
1 Pull and twist the quick release cord holder to
unwrap the power cord completely. Plug into an
electrical outlet. (fig. 6)
2
The STEAM CONTROL button will flash blue. If the
light does not turn on, reference the troubleshooting
section on page 10. (fig. 7)
www.sharkclean.eu/uk 5