Dell OptiPlex 330 Quick Reference Manual page 55

C M O S C H E C K S U M E R R O R
Replace battery.
C P U F A N F A I L U R E
I S K E T T E D R I V E
D 0
configuration information may not match the hardware configuration. Check cable
connections.
I S K E T T E R E A D F A I L U R E
D
loose. Replace the floppy disk/check for a loose cable connection.
H A R D - D I S K D R I V E F A I L U R E
POST. Check cables /swap hard disks.
H A R D - D I S K D R I V E R E A D F A I L U R E
E Y B O A R D F A I L U R E
K
N O B O O T D E V I C E A V A I L A B L E
partition.
• If the floppy drive is your boot device, ensure that the cables are connected and
that a bootable floppy disk is in the drive.
• If the hard drive is your boot device, ensure that the cables are connected and
that the drive is installed properly and partitioned as a boot device.
• Enter system setup and ensure that the boot sequence information is correct.
N O T I M E R T I C K I N T E R R U P T
malfunctioning or motherboard failure.
O N S YS T E M D I S K O R D I S K E R R O R
N -
a bootable operating system or remove the floppy disk from drive A and restart the
computer.
— Possible motherboard failure or RTC battery low.
— CPU fan failure. Replace the CPU fan.
S E E K F A I L U R E
— A cable may be loose, or the computer
— The floppy disk may be defective or a cable may be
— Possible hard disk drive failure during HDD
— Possible HDD failure during HDD boot test.
— Keyboard failure or keyboard cable loose.
— The system cannot detect a bootable device or
— A chip on the system board might be
— Replace the floppy disk with one that has
Quick Reference Guide
55