Panasonic TH-80BF1U Operating Instructions Manual page 13

LCD Display
Declaration of Conformity (DoC)
"Hereby, Panasonic Corporation declares that this Display is in compliance with the essential requirements and
other relevant provisions of the Directive 1999/5/EC."
If you want to get a copy of the original DoC of this Display, please visit the following website:
http://www.doc.panasonic.de
Authorized Representative:
Panasonic Testing Centre
Panasonic Service Europe, a division of Panasonic Marketing Europe GmbHn
Winsbergring 15, 22525 Hamburg, Germany
This Display is intended to be used in the following countries.
Albania, Austria, Belgium, Bulgaria, Cyprus, Czech Republic, Denmark, Estonia, Finland, France, Germany, Greece,
Hungary, Italy, Iceland, Latvia, Lithuania, Luxembourg, Malta, Netherlands, Norway, Poland, Portugal, Romania,
Slovakia, Slovenia, Spain, Sweden, Switzerland, Turkey, United Kingdom
The wireless LAN feature of this Display shall exclusively be used inside buildings.
UAE
UAE-TRA
REGISTERED No:
ER0081229/12
DEALER No:
DA0052708/10
Singapore
Complies with
IDA Standards
DB01017
Thailand
"
Notes on Using Wired LAN
When setting up the Display at a place, where electric statistic occurs often, take a sufficient antistatic
measure before start using.
•
When the Display is used at a location, where static electricity occurs often, such as on a carpet, a wired LAN
communication is disconnected more often. In that case, remove static electricity and the noise source that may
cause problems with an antistatic mat, and re-connect the wired LAN.
•
In rare cases, the LAN connection is disabled due to static electricity or noise. In that case, turn off the power of
the Display and the connected devices once and then re-turn on the power.
The Display may not work properly due to strong radio wave from the broadcast station or the radio.
•
If there is any facility or equipment, which outputs strong radio wave, near the installation location, set up the
Display at a location sufficiently far from the source of the radio wave. Or, wrap the LAN cable connected to the
DIGITAL LINK/LAN terminal by using a piece of metal foil or a metal pipe, of which is grounded at both ends.
. . 1012-2551"
Precautions for use
13