Ikelite 6146.05 Instruction Manual page 9

Step 3 - Install Camera in Housing - continued
Diagram A
Pull to Remove
4. Using a coin or flathead screwdriver
(preferred), secure the camera Mounting
Tray to the camera tripod mount,
Diagram B. Tighten camera firmly to
avoid movement on tray. The Mounting
Tray only attaches one way with the
Mounting Tray Tab to the back of the
camera.
An additional 1/4-20-inch tray hole allows
attachment to a land tripod stand.
5. Gently slide the camera with Mounting Tray back into the Mounting Plate,
Diagram C, page 10. Using your thumbs, push against the Mounting Tray
until it stops sliding forward into the Mounting Plate. Give the Tray an extra
push to make sure it is properly seated all the way forward in the Mounting
Plate and no housing controls are in the way.
Mounting Tray
Mounting Plate
Diagram B
Mounting
Tray Tab
HDMI
Tighten here
9