Hyundai HTX 646 User Manual page 39

2.3 OSD LANGUAGE
Select on-screen display language.
2.4 CLOSED CAPTIONS
This function doesn't work when the disc is without captions. If the caption is OFF, press
[SUBTITLE] key on the remote controller to turn the captions on.
2.5 SCREEN SAVER
If the SCREEN SAVER is set ON and the unit is switched on without a disc playing for several
minutes, a moving picture appears on the screen and the unit will go to standby mode after 20
minutes. You can press the [STANDBY] key on the remote controller to activate it.
2.6 LAST MEMORY
When this function is on, the unit can memorize the time elapsed from the last time you
played the disc. When playing next time, it will resume playing from the memorized time.
3. AUDIO SETUP PAGE
3.1 ANALOG AUDIO SETUP:
3.1.1 DOWNMIX:
LT/RT: The audio out is Left and Right channel format even if the original sound is 5.1CH for-
mat.
STEREO: The audio out format is stereo even if the original sound is 5.1CH format.
3D SURROUND: The audio out is virtual surround sounds.
5.1CH: Turn off downmix function. If playing 5.1CH discs or the unit is connected to 5.1 chan-
nel amplifier, this item should be selected.
3.1.2 FRONT, CENTER, REAR and SUB-WOOFER SPEAKER
If your speaker system includes the above speakers, you can set these items according
the real speaker status.
3.1.3 DIALOG: The DIALOG mode is available, you can press up/down direction key to adjust
it.(In the DOWNMIX mode, LT/RT or STEREO is selected.)
3.1.4 D.R.C.: This item is available when item DOWNMIX is seated to LT/RT or STEREO. You can
use the direction key [UP]/[DOWN] to adjust it .
3.2 DIGITAL AUDIO SETUP PAGE
3.2.1 DIGITAL OUTPUT
SPDIF OFF: No digital output, only analog audio output.
ALL: If this item is selected, you can set up the RAW.
PCM ONLY: In SPDIF/PCM mode, setup PCM channel according to your preference.
3.2.2 LPCM OUT
Select PCM frequency at 48kHz or 96kHz in PCM ONLY mode.
Note: some amplifiers don't support 96kHz sampling which will effect coaxial output.
3.3 DOLBY DIGITAL SETUP
3.3.1 DUAL MONO
Stereo: Set audio output to the stereo output.
L-Mono: Set audio output the mono-left channel.
R-Mono: Set audio output the mono-right channel.
Mix-Mono: Set audio output the Mix mono channel.
EN - 39
EN