Bosch AQT 42-13 Original Instructions Manual page 12

OBJ_BUCH-2164-001.book Page 12 Friday, April 11, 2014 12:41 PM
12 | English
Power supply
 The voltage indicated on the rating
plate must correspond to the volt-
age of the power source.
 We recommend that this equipment
is only connected into a socket
which is protected by a circuit-
breaker that would be actuated by a
30 mA residual current.
 Remove the plug from socket when-
ever the machine is left unattended
for any period.
 The electric supply installation
should comply with IEC 60364-1.
 If the supply cord is damaged, it
must be replaced by the manufac-
turer, its service agent or similarly
qualified persons in order to avoid a
hazard.
 If the plug is damaged, pay attention
to the following:
 Plugs and sockets situated near the
work site or outdoors should be to
class IP 55 of BS 5490 to provide
adequate protection against ingress
of water, etc. and cable entries re-
quire effective sealing. Rubber
shrouds should be provided over ca-
ble glands. Drip-proof (class IP X2 of
BS 5490) plugs and sockets to
BS 4343 are suitable for use in-
doors where the plug is away from
the water spray area where the ap-
pliance is in use.
 Never touch the mains plug with wet
hands.
 Do not pull plug while operating the
device.
F 016 L81 056 | (11.4.14)
 Do not run over, crush or pull the
power supply cable or extension
lead, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
 Do not use the appliance, if the pow-
er supply cable or important parts,
e. g. high-pressure hose, trigger gun
or safety devices are damaged.
 Warning: Inadequate extension
cords can be dangerous.
 If an extension cord is used, the plug
and socket must be of watertight
construction. The extension cord
must have a cross section in accord-
ance with the operating instructions
and be protected against splashed
water. The connection must not be
in water.
 When replacing plugs on the power
supply cable or extension lead the
spray water guard and mechanical
stability must remain intact.
Water connection
 Comply with the regulations of your
water supply company.
 All connecting hoses must have
properly sealed joints.
 Make sure that the supply hose is at
least 12.7 mm (1/2") in diameter
and is reinforced.
 The appliance should never be used
on the drinking water supply with-
out a back flow valve. Water which
has passed the back flow valve is re-
garded as undrinkable.
 The high-pressure hose must not be
damaged (danger of bursting). A
damaged high-pressure hose must
Bosch Power Tools