Worcester Greenstar Danesmoor External Regular ErP User Instructions

Advertisement

User Instructions
Floor standing oil fired condensing boiler conventional flue and room sealed flue
Greenstar Danesmoor External Regular
and
ErP
External System
12/18, 18/25 & 25/32
ErP
For fully pumped open vent and sealed central heating systems and domestic hot water cylinders.
For use with Kerosene (Class C2) only.
UK

Advertisement

Table of Contents
loading

Summary of Contents for Worcester Greenstar Danesmoor External Regular ErP

  • Page 1 User Instructions Floor standing oil fired condensing boiler conventional flue and room sealed flue Greenstar Danesmoor External Regular External System 12/18, 18/25 & 25/32 For fully pumped open vent and sealed central heating systems and domestic hot water cylinders. For use with Kerosene (Class C2) only.
  • Page 2: Table Of Contents

    4.2 Servicing ....... . 7 There is also the reassurance of our parts and labour guarantee - backed up by Worcester Total Cover, an optional complete maintenance scheme to keep your appliance operating at peak External filling loop (sealed system only) .
  • Page 3: Key To Symbols And Safety Instructions

    Key to symbols and safety instructions Key to symbols and safety instructions Key to symbols A step in an action sequence A sequence of defined actions or steps carried out in order to Warnings complete a task. ▶ Action Safety instructions in this document are ▶...
  • Page 4: Safety Instructions

    • Do not modify the appliance or flue system in any way. Worcester, Bosch Group accepts no liability arising from any such actions. This does not affect your statutory rights. Greenstar Danesmoor External & External System...
  • Page 5: Using Your Boiler

    Using your boiler Using your boiler Controls 4. Temperature control 5. Pressure gauge (System boiler only) 6. Boiler mode indicator 7. Mode switch 8. Reset button - Heating (behind the front panel) 9. Reset button - Flue thermostat (behind the front panel) 10.
  • Page 6: Operating The Boiler

    Using your boiler Operating the boiler 3.2.1 Switching the boiler on/off ▶ To switch on the boiler; turn on the water, oil and electricity supply to the boiler. ▶ Check the programmer/timer is correct and is set to ON. ▶ Set the room thermostat to the desired setting. ▶...
  • Page 7: Maintenance

    If you would like to know more about servicing options from Worcester, Bosch Group, please visit worcester-bosch.co.uk. Please tick the appropriate box on your warranty registration card for further details of the Worcester, Bosch Group Service Contract. When your boiler requires servicing please contact a Worcester, Bosch Group contact centre (see the back cover for details).
  • Page 8: External Filling Loop (Sealed System Only)

    External filling loop (sealed system only) External filling loop (sealed system only) This appliance is fitted to a sealed heating system which is pressurised. Your installer will advise you of the minimum and maximum pressure indicated on the pressure gauge. ▶...
  • Page 9: General Information

    General information General information WARNING: 600mm ▶ External equipment operating at 230 Volts must not be serviced or repaired during adverse weather conditions. ▶ Do not use pressure washers or steam cleaners on this appliance or cabinet. Fuel This appliance is designed to use 28 second kerosene, no other fuel must be used.
  • Page 10: General Notes

    General information General notes To get the best from your boiler, read these instructions carefully. Central heating system During the first few hours of operation of the central heating system, check that all radiators are being heated at an even rate.
  • Page 11: Fault Finding

    In the event that the appliance stops functioning or does not perform as expected, you can carry out a few simple checks. These checks are some of the most common causes and are listed in the table below. Should the problem persist or if other fault codes are displayed, then it will be necessary to contact Worcester, Bosch Group. Problem...
  • Page 12: Fault Conditions

    Fault finding Fault conditions The ‘Boiler mode’ and ‘Lockout’ lights can indicate some basic 1. Accessing controls fault conditions: 1. Accessing controls: ▶ Undo the screws on the bottom of the front panel using the tool provided. The panel can be removed by pulling out at the base and then sliding down to disengage from the lid.
  • Page 13: Fault Or Breakdown

    Fault or breakdown Fault or breakdown This boiler is supported in mainland UK by Worcester, Bosch Boiler data label Group, part of Bosch Thermotechnology Ltd. The data label [1] can be found on the inside of the right hand side panel.
  • Page 14: Energy Saving

    Energy saving Energy saving Tips on energy saving Room thermostats Roof insulation Reducing the setting of the room thermostat by 1°C can reduce Around 30% of the heat loss from a property is through the fuel consumption by up to 10%. roof.
  • Page 15: Your Guarantee

    Terms and Conditions. To read the full Terms & Conditions please visit us on-line at www.worcester-bosch.co.uk/guarantee. The Guarantee Registration form is available on this same page and can be Refer to the boiler data label inside the casing completed and submitted electronically.
  • Page 16 0330 123 9119 TRAINING: 0330 123 0166 SALES: 0330 123 9669 Worcester, Bosch Group Cotswold Way, Warndon, Worcester WR4 9SW. Tel. 0330 123 9559 Worcester, Bosch Group is a brand name of Bosch Thermotechnology Ltd. worcester-bosch.co.uk 6 720 813 726 (2014/09)

Table of Contents