Advertisement
D-2)
Filter care
Central Filter (Fig. 1) Part no. AMC8F03D1100
The central filter (foam filter), is installed in the dust bag compartment to
protect the motor from dirt.
When it becomes dirty, simply rinse it out in warm water and dry it thoroughly
before replacing.
To remove the central filter, hold the filter at the top (as illustrated) and pull it out.
Important: Ensure that the filter is completely dry before re-installing it into the
cleaner.
Clean Air Filter (Fig. 2) Part no.:
AMC8F28T1000 / MC-E760, MC-E761, MC-E762, MC-E763, MC-E785
AMC8F28T3000 / MC-E783, MC-E787
The clean air filter, is installed in the rear side of the cleaner. This filter retains any
small dust particles which may be present in the expelled air.
It is advisable to change the clean air filter when it becomes dirty. As a guide,
once or twice a year is usually sufficient depending on use.
To change the clean air filter, hold the exhaust cover (as illustrated) and pull it out.
IMPORTANT: Never use the cleaner without the correct filters properly installed. Failure to
do so may result in motor damaged.
Never hold the exhaust cover to carry the cleaner.
Fig. 1
Fig. 2
Advertisement
