ENGLISH (Original instructions)
1-1. Battery cartridge
1-2. Red part
1-3. Button
2-1. Switch trigger
3-1. Reversing switch lever
4-1. Lamp
SPECIFICATIONS
Fastening torque
No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications and battery cartridge may differ from country to country.
• Weight, with battery cartridge, according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
For Model BFL300F
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
The noise level under working may exceed 80 dB (A).
Wear ear protection.
Vibration
The
vibration
total
determined according to EN60745:
Work mode: screwdriving without impact
Vibration emission (a
Uncertainty (K) : 1.5 m/s
For Model BFL400F, BFL401F
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Uncertainty (K) : 3 dB(A)
Explanation of general view
4-2. LED indicator
5-1. Screw
6-1. Angle head
6-2. Ring
6-3. Scale
6-4. Compression spring
Model
Hard joint
With battery
BH1427
Soft joint
Hard joint
With battery
BL1430
Soft joint
Square drive
-1
)
Dimensions
Net weight
Rated voltage
) : 72 dB(A)
pA
value
(tri-axial
vector
2
) : 2.5 m/s
or less
h
2
) : 73 dB(A)
pA
BFL300F
16 - 30 N • m
16 - 30 N • m
16 - 30 N • m
16 - 27 N • m
9.5 mm
506 mm x 73 mm x 104 mm
1.9 kg
ENE033-1
The noise level under working may exceed 80 dB (A).
Vibration
The
vibration
determined according to EN60745:
Work mode: screwdriving without impact
ENG104-1
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
ENG204-2
WARNING:
sum)
The vibration emission during actual use of the
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
ENG104-1
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
3
6-5. Yellow line
6-6. Hole for adjusting grip
6-7. Adjusting grip
8-1. Socket
8-2. Hole
8-3. Pin
400
510 mm x 73 mm x 104 mm
D.C. 14.4 V
Wear ear protection.
total
value
(tri-axial
) : 2.5 m/s
h
2
BFL400F/BFL401F
25 - 40 N • m
25 - 40 N • m
25 - 40 N • m
25 - 38 N • m
9.5 mm
260
2.0 kg
ENG204-2
vector
sum)
2
or less
ENG901-1