Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Eldes EWP2
Summary of Contents for Eldes EWP2
- Page 1 EWP2 WIRELESS MOTION DETECTOR...
-
Page 2: Contents Of Pack
ELDES alarm system. It is possible to pair up to 16 EWP2 devices with EPIR3 or EPIR2 system, while with ESIM364 alarm system - up to 32 EWP2 devices at a time. The maximum wireless connection range is 150m (492.13ft) ( (in open areas). -
Page 3: Technical Specifications
Range of operating temperatures ......-10... +55°C (+14... +131°F) Humidity ................0-90% RH @ 0... +40°C (0-90% RH @ +32... +104°F) (non-condensing) Dimensions ..............124x67x58mm (4.88x2.64x2.28in) Compatible with alarm systems .......ELDES Wireless * The operation time might vary in different conditions. 2.2. Main Unit and LED Functionality... -
Page 4: Installation
Before installing the wireless device, we highly recommend to refer to RADIO SYSTEM INSTALLATION AND SIGNAL PENETRA- TION manual located at www.eldes.lt/download The system should be installed indoors, in stationary environment ONLY. Choose a location where unauthorised entry is most likely. - Page 5 (9.84ft) ATTENTION: By default, EWP2 PCB is in the right position. DO NOT change the PCB position in the enclosure. When installing EWP2, follow the recommendations for the installation to achieve the strongest wireless signal: Never install in the following...
- Page 6 5. Pair the device with the alarm system using ELDES Configuration Tool software. Open Wireless Device Management section and enter the 8-character Device ID located on the EWP2 enclosure or select the device icon with a message NOT CONNECTED indicated next to it and click the Add button.
- Page 7 7. Upon the successful pairing process, the message indicated next to EWP2 device icon will turn to CONNECTED. If the attempt to pair is unsuccessful, try to move EWP2 closer to the ELDES alarm system and pair anew. 8. Move away from the EWP2 motion detection area and wait for 2 minute-period or longer, while the device auto-calibrates its built-in PIR sensor.
-
Page 8: Temperature Sensor
• one located on the front side of the PCB supervising the front cover in case it is illegally opened (see fig. #1). • the other one located on back of the PCB supervising the back side of the enclosure in case the EWP2 is illegally removed from the holder (see fig.#1 and fig.#16). -
Page 9: Restoring Default Parameters
UAB” will not take any responsibility regarding personal or property or revenue loss while using the system. “ELDES UAB” liability according to local laws does not exceed value of the purchased system. “ELDES UAB” is not affiliated with any of the Internet providers therefore is not responsible for the quality of Internet service. - Page 10 Made in the European Union www.eldes.lt...
Need help?
Do you have a question about the EWP2 and is the answer not in the manual?
Questions and answers