Mounting The Device; Mounting On A Wall; Mounting On A Horizontal Surface; Figure 10: Wall Mounting - Alfa Network AIP-W502 User Manual

M D
OUNTING THE EVICE
M W
OUNTING ON A ALL
M
OUNTING ON A
H S
ORIZONTAL URFACE
The Mini Broadband Router can be mounted on any horizontal surface, or
on a wall. The following sections describe the mounting options.
The Mini Broadband Router should be mounted only to a wall or wood
surface that is at least 1/2-inch plywood or its equivalent. To mount the
unit on a wall, always use its wall-mounting slots.

Figure 10: Wall Mounting

To mount on a wall, follow the instructions below.
1.
Mark the position of the two screw holes on the wall. For concrete or
brick walls, you will need to drill holes and insert wall plugs for the
screws.
2.
Insert two 20-mm M4 tap screws (not included) into the holes, leaving
about 2~3 mm (0.08~0.12 inches) clearance from the wall.
3.
Line up the two mounting points on the unit with the screws in the wall,
then slide the unit down onto the screws until it is in a secured position.
To keep the Mini Broadband Router from sliding on the surface, the unit has
four rubber feet on its base.
It is recommended to select an uncluttered area on a sturdy surface, such
as a desktop or table. The unit can also be protected by securing all
attached cables to a table leg or other nearby fixed structure.
– 29 –
C 1 |
Installing the Mini Router
HAPTER

Mounting the Device

Mounting Slots