Placement Of The Air Compressor - Husky C302H Use And Care Manual

Pre-Operation (continued)
Part Description
Thermal Overload Reset: (not shown) This motor has a manual thermal overload protector. If the motor
overheats for any reason, the overload protector will shut off the motor. The motor must be allowed to
cool down before restarting. To restart:
1. Place the Auto/Off switch in the "Off" position.
K
2. Allow the motor to cool.
3. Depress the red reset button on the motor.
4. Place the Auto/Off switch in the "Auto" postion to restart the motor.
Pressure Release Valve: (not shown) The pressure release valve located on the side of the pressure
switch, is designed to automatically release compressed air from the compressor head and the outlet
tube when the air compressor reaches "cut-out" pressure or is shut off. The pressure release valve allows
L
the motor to restart freely. When the motor stops running, air will be heard escaping from this valve for
a few seconds. No air should be heard leaking when the motor is running or after the unit reaches "cut-
out" pressure.

PLACEMENT OF THE AIR COMPRESSOR

WARNING: If any parts are damaged or missing do not
operate this product until the parts are replaced. Failure
to heed this warning could result in serious personal
injury.
CAUTION: Do not use in an environment that is dusty
or otherwise contaminated. Using the air compressor in
this type of environment may cause damage to the unit.
NOTICE: Long lengths of electrical wiring could cause power loss to
the motor.
□
Place the air compressor in a clean, dry, and well
ventilated area.
□
The air compressor must be positioned at least 18
in. (0.5 m) away from the wall or other obstructions
that will interfere with the flow of air.
□
Locate the air compressor as close to the main
power supply as possible to avoid using long
lengths of electrical wiring.
□
The air filter must be kept clear of obstructions
which could reduce the air flow to the air
compressor.
C302H_HUSKY_manual_5-15-ENG.indd 10
10
18 in.
(0.5 m)
6/10/15 12:05 PM