Generac Power Systems 6.75 Operator's Manual page 22

Trimmer Cord
Trimmer
Guard
Figure 33
Transmission
Guard
Bolts and Flat
Washers
Figure 34
Locknut
Eyelet
Bolt and
Locknut
Cable Bracket
Figure 35
Bracket
"Z" Bend
Figure 36
®
GENERAC
22 TRIMMER/MOWER
Replacing the Drive Belt (Self Propelled model)
Bolts and Flat
Washers
Tools and Parts needed:




1. Tip the machine back onto the handlebar to access the underside.
2. Remove the Trimmer Cords from the Head Assembly.
3. Remove the four Trimmer Guard Bolts and Flat Washers with a 3/8"
4. Remove the four Transmission Cover Bolts and Flat Washers with a 3/8"
5. Remove the Locknut that is securing the Drive Cable Eyelet to the Bail Bar
6. Remove the Cable Bracket from the Handlebar using two 7/16˝ Wrenches.
7. Disconnect the Z-bend end of the Drive Cable from the Bracket (Figure 36).
8. Loosen the rear Drive Belt Guide Locknut using a 7/16" Wrench and rotate
9. Loosen the left side Locknut from the Engine Belt Guide to allow for some
10. Rotate the Transmission down toward the back enough to slide the small
Bail Bar
3/8" Wrench
Two 7/16" Wrenches
Philips Head Screwdriver
V Belt: 3L130
Wrench. Remove the Trimmer Guard (Figure 33).
Wrench. Remove the Transmission Cover (Figure 34).
using a 7/16˝ Wrench and remove the Eyelet from the Bail Bar (Figure 35).
the Guide out of the way (Figure 37).
movement of the Belt Guide.
Drive Belt from the Engine Pulley groove.
Transmission
Locknut
Figure 37
Engine Belt
Guide
Drive Belt Guide
Lock
Nut
Drive
Belt