Generac Power Systems 6.75 Operator's Manual page 18

4. Looking down at the top of the Frame, turn the Mow-Ball
®
Note: If the Mow-Ball continues to turn, but does not come off, check to be sure that you locked the Screwdriver into the shaft.
If the Mow-Ball will not turn by hand a 9/16" Socket can be used on the Bolt (inside the bottom of the Mow-Ball) to loosen it.
You may need to clean grass or debris out of the recess first.
5. Slide the Line Plates, Anti Wrap Canister and Spacer off the Shaft (Figure 24).
Anti Wrap
Canister
Tab Holes
®
Mow-Ball
Figure 24
®
GENERAC
18 TRIMMER/MOWER
Assembly
Improper installation can cause damage to the trimmer bearings. Follow
Spacer
these directions carefully to protect your machine from damage. Reassemble
the components in the order shown in figure 24.
1. Place the Spacer and Anti Wrap Canister (with the lip facing up) onto the
Shaft (Figure 24).
2. Ensure the Line Plates are facing top side up as shown. Align the flats at the
Line Plates
center of the Line Plates with the flat on the shaft as you slide them onto the
Shaft. Ensure the Tabs on the underside of the Line Plates are fully into the
holes on the tops of the Line Plates so they will fit together tightly.
Flats in Line
3. Place the head of the Mow-Ball
Plates to Match
with Shaft bottom of the Mow-Ball
4. Looking down at the top of the Frame, hold the Bolt Head in place with your
finger and turn the Mow-Ball
Shaft.
®
Mow-Ball
5. Tighten the assembly securely by turning the Mow-Ball
Bolt
when looking down on the top of the Frame.
6. Remove the Screwdriver.
Note: When finished there should be no gaps between any of the components.
Always make sure you remove the screwdriver from the head assembly when
finished. Failure to remove the screwdriver could cause injury when the head
assembly is engaged.
®
clockwise until it unscrews completely from the Bearing Housing.
®
®
.
®
counterclockwise to start the Bolt into the
Bolt so it is sitting in the hex cavity at the
®
counterclockwise