Baxi Platinum 2 Combi 28 GA User's Operating Instructions & Important Warranty Information page 11

04. November 2008 08:50
Tuesday
1.6 bar
Easy Menu
Button
i-THINK Controller
ROOM TEMPERATURE SETPOINT
Flow temp setpoint room stat
STEP 1 - Turn the Selector
Button and the temperature
will appear. Turn the Button
again and whilst flashing keep
turning the dial to display the
required temperature.
© Baxi Heating UK Ltd 2011
Menu Button
Selector Button
Temporary room setpoint
STEP 2 - Press the Selector
Button to select.
5.3
1. From the main screen - turn the Selector Button until the
desired temperature is displayed, press the Button to confirm.
2. If the temperature is being adjusted from the appliance
connected to two heating circuits, the heating circuit must be
chosen first.
3. Between the programmed times there is a minimum setback
or reduced temperature which is set to 5°C (see Section 5.1
STEPS 1 to 6). This may be permanently changed to set a higher
minimum temperature ie. 10°C or temporarily changed by
turning the Selector Button between a programmed period and
selecting the desired temperature. This facility may be used to
heat the house outside the programmed periods.
4. The reduced temperature setting will revert to the
Valve confirmed
permanently stored value at the beginning of the next
programmed period.
5.0 Mode Selection/Temp Adjustment
Adjusting the Room temperature set point
11