Copying Audio Cassettes To A Pc; Connecting The Device To Your Pc - Silvercrest SKD 1000 A3 User Manual And Service Information

Copying Audio Cassettes to a PC

To be able to digitize and store your cassettes on a PC, you must first have installed the supplied
AudioLava software on your computer (see page 12, Installing AudioLava).

Connecting the device to your PC

1. Connect your SilverCrest SKD 1000 A3 to a switched-on PC using the supplied USB cable.
Connect the end of the cable with the small USB connector to the USB port (3) on the
device, and the end with the large USB connector to a USB 2.0 port on your PC.
2. Your SilverCrest SKD 1000 A3 should then be detected automatically by the operating
system and the necessary drivers should be installed automatically (this step is only
performed the first time you connect the SilverCrest SKD 1000 A3 to your PC).
When the cable has been connected and the PC is switched on, power will be
supplied to your SilverCrest SKD 1000 A3 by the computer via the USB cable.
You can leave the batteries in place or the optional mains adapter connected.
16
SilverCrest SKD 1000 A3
English