Toshiba MV19K2 Service Manual page 13

2-6: LINK ASS'Y (Refer to Fig. 2-6)
1. Set the Link Ass'y to the Eject position.
2. Remove the (A) side of the Link Ass'y first, then remove
the (B) side.
Link Ass'y
(A)
Main Chassis
2-7: LOADING MOTOR ASS'Y (Refer to Fig. 2-7)
1. Remove the Link Lever.
2. Remove the Dumper Spring.
Remove the 2 screws 1.
3.
Unlock the support 2 and remove the Loading Motor
4.
Ass'y.
Unlock the 2 supports 3 and remove the Deck PCB
5.
(BOT).
Dumper Spring
Main Chassis
• Screw Torque: 5 ± 0.5kgf•cm
2-8: SENSOR COVER L (Refer to Fig. 2-8)
Unlock the support 1 and remove the Sensor Cover L.
1.
Unlock the 2 supports 2 and remove the Deck PCB
2.
(EOT).
Main Chassis
DISASSEMBLY INSTRUCTIONS
(B)
Link Ass'y
Main Chassis
Fig. 2-6
1
Loading Motor Ass'y
2
3
1
Deck PCB
(BOT)
Link Lever
Fig. 2-7
Sensor Cover L
Deck PCB
(EOT)
2
1
2
Fig. 2-8
2-9: TENSION ASS'Y (Refer to Fig. 2-9-A)
1. Move the Inclined S Ass'y to the back side.
Unlock the support 1 and remove the S Reel Stopper.
2.
3. Remove the Tension Spring.
Unlock the support 2 and remove the Tension Arm
4.
Ass'y.
5. Remove the Tension Adjust.
Unlock the 2 supports 3 and remove the Tension Band
6.
Ass'y.
Unlock the support 4 and remove the Tension Holder.
7.
3
3
Tension Spring
2
4
S Reel Stopper
1
NOTE
When you install the Tension Adjust, install as shown in
Fig. 2-9-B. (Refer to Fig. 2-9-B)
Adjust the direction of the Marker to inside.
2-10: T BRAKE ASS'Y (Refer to Fig. 2-10)
1. Remove the T Brake Spring.
2. Remove the T Brake Ass'y.
T Brake Ass'y
Tension Adjust
Tension Band Ass'y
Tension Arm Ass'y
Tension Holder
Inclined S Ass'y
Fig. 2-9-A
Fig. 2-9-B
T Brake Spring
Fig. 2-10