Table of Contents
Advertisement
specting the
dryer
nnecting the
mains plug
oading laundry
woollens"
he programme
1
drying programme ...
2
idual requirements
sitive and only
d lightly.
3
he Start/Stop button
with the fluff filter
that require a longer
stane, acetate silk.
d ironing' phase after
ogramme.
Do not pull out/empty the
condensate container when drying is in progress.
Drying
Condensate container with filter
Drum interior
light (depending
Control panel
on the model)
Drum
Two-part
fluff filter
Air inlet
Drying
Emptying condensation
Empty the container after each drying cycle, not during drying.
Remove the condensate container and hold it level.
1.
2.
Pour out the condensation.
3.
Always push container in fully until it clicks into place.
If the Empty water indicator lamp flashes despite the container having
been emptied
Filter in condensate container, page 9.
Cleaning the fluff filter
Clean fluff filters reduce energy consumption.
The fluff filter consists of two parts. Clean the inner
and outer filter after every drying cycle:
1.
Open the door. Remove fluff from the door/door area.
2.
Pull out both parts of the fluff filter.
3.
Remove fluff from the edge of the shaft. Fluff should not fall
into the open shaft.
4.
Open the filter and remove all the fluff.
5.
Rinse both parts under running water and dry thoroughly.
6.
Close the inner and outer filter, put them back together
and reinsert them into the appliance.
Switching off the dryer
Turn the programme selector to Off.
Do not leave laundry in the dryer.
Removing the laundry
Your dryer is equipped with an automatic reduced ironing function. The drum is moved at specific time
intervals for 60 minutes once the programme has ended. The laundry stays loose and fluffy (or
120 minutes if the additional Less Ironing function is selected).
End of programme
as soon as AntiCrease/End indicator lamp lights up.
Interrupt programme
Adding or removing laundry.
The drying operation can be interrupted briefly to add or remove laundry. However, it must then be
continued until it has finished.
1.
Open the door. The drying process is interrupted.
2.
Add or remove laundry then close the door.
3.
If required, select a new programme and additional functions.
4.
Press the Start/Stop button. The remaining time is updated after a few minutes.
3
4
4
Advertisement
Table of Contents
