Advertisement
P2™
AC INPUT/ Fuse In IEC Jack: 100V-240V~50Hz/60Hz
10
Connect to main power (100~240V AC) with the included power chord. It is built-in with one electrical
fuse. If damaged, please replace the fuse with the same specification.
Fuse In IEC Jack
To replace the fuse, be sure to remove the IEC power cord from the IEC socket. The fuse holder tray is located beneath the IEC
socket cavity. Pry the fuse holder tray out with a small flat blade screwdriver placed under the center of the top edge of the fuse tray,
and gently lever the fuse tray out. The fuse is held in a clip in the fuse tray, and should be removed and replaced with a fresh 5 X
20mm 250V type fuse of the appropriate current rating. A spare fuse should be located in a hollow compartment in the fuse tray,
below and behind the clip, this would be the one that is NOT clipped into the fuse tray clips.
Then, once the fresh fuse has been put in place, re-insert the fuse tray into the IEC connector assembly, and make sure it is fully
seated and flush with the outside of the IEC connector assembly.
It is recommended that to assure future convenience of having a spare, that a spare fuse be obtained and placed in the hollow com-
partment at the earliest convenient time.
5
Advertisement
