Questions And Answers - Gigaset A490 Manual

Authorisation
This device is intended for connection to
analogue networks outside the European
Economic Area (with the exception of Swit-
zerland) depending on national type
approval.
Country-specific requirements have been
taken into consideration.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regula-
tions laid down in Directive 1999/5/CE.
A copy of the 1999/5/EC Declaration of
Conformity is available at this Internet
address:
www.gigaset.com/docs
17

Questions and answers

If you have any queries about the use of
your telephone, visit our website at
www.gigaset.com/service for 24-hour sup-
port. The table below contains a list of com-
mon problems and possible solutions.
Problem Cause
Nothing The hand-
appears in set is not
the display. switched
on.
The batter-
ies are flat.
No wireless The hand-
connection set is out-
to the base side the
station, range of
Base search the base
flashes in station.
the display.
The base
station is
not turned
on.
No wireless The hand-
connection set is not
to the base registered
station,
Register
HS flashes
in the dis-
play.
You cannot The phone
hear a cord sup-
ringer/dial- plied has
ling tone not been
from the used or
fixed line has been
network. replaced
by a new
cord with
the wrong
jack con-
nections.
Error tone The sys-
sounds after tem PIN
system PIN you have
prompt. entered is
incorrect.
PIN forgot-
ten.
Solution
a
Press the end call
key for approx.
5 seconds or place the
handset in the base
station.
Charge or replace the
batteries.
Move the handset
closer to the base
station.
Check the mains con-
¢
nector on the base sta-
tion page 5.
¢
Register the handset
page 13.
Please always use the
phone cord supplied or
ensure that the
pin connections are
correct when purchas-
ing from a retailer:
3-4 assignment of
telephone leads/
EURO CTR37.
Reset the system PIN to
the default 0000 using
¢
the software
reset page 15.
All settings are reset.
All lists are deleted.