Page 2
• When cutting or drilling into wall or ceiling, do not damage electrical • The fire department is being called. wiring and other hidden utilities. • You can fight the fire with your back to an exit. • Duct fans must always be vented to the outdoors. fantech...
Page 3
SGHL 30 & SGHL 36 Dimensions Speed/Light Controls SGHL 30 & SGHL 36 Dimensions Model UPC # Duct † Dimmable Halogen SHL36 47036 Lights SHL42 47042 SHL48 47048 Dimensional information is in inches All dimensional tolerances are 0” to 1/16” unless otherwise stated. 7/8" (22.23mm)
Choosing the right remote mount blower (see page 7) Look on page 7 for a list of Fantech fans recommended for use with the SHL & SGHL. Series Range Hood Liners. Some models remotely mount in the attic. Other models are used when installation requires a roof mount or wall mount fan.
1. Ensure that the power supply is disconnected before proceeding. 4. The Fantech liner is supplied with a 5.0 amp variable speed fan con- 2. Verify that the power supply matches the ratings found on the trol.
Page 6
The frequency of cleaning Replacement filters should be adjusted according to the type and amount of cooking. Best Order online at www.fantech.net results will be achieved by cleaning soiled components as soon as pos- sible.
Page 7
† Typical airflow is an estimate based on a system with 20’ of duct, two 90° elbows, a backdraft damper, roof cap and filters. * Fans will meet most local code requirements but will produce less than Fantech’s recommended ventilation rate of 100 cm per foot of hood width.
DURING ENTIRE WARRANTY PERIOD: END USER, AS CREDIT TO DISTRIBUTOR’S ACCOUNT WILL BE Fantech will repair or replace any part which has a factory defect in PENDING INSPECTION AND VERIFICATION OF ACTUAL DEFECT BY workmanship or material. Product may need to be returned to the FANTECH.