Table of Contents
Advertisement
Transport and storage
Installation
Required tools
3062815_201508
General preparations
-
For handling and storage of the collector pile only use the packing strips
and pallets.
-
Never move more than 16 collectors in a single pile and never store more than
24 collectors in a single pile.
-
Never move collectors with the glass facing down.
-
To prevent damage, never carry collectors by the collector connectors or
CAUTION
put them down on the connectors.
-
Never place the collector back onto uneven surfaces.
-
Store collectors only in dry places that are free of dust.
-
We recommend the use of transport handles (available as accessories).
The collector must not be pulled onto the roof exclusively by the rivet nuts!
Do not step underneath the collector during transport. (see picture)
In case of jerky movements the rivet nuts can tear off and the collector
can fall.
The installation and commissioning must only be carried out by authorised
contractors. This contractor will be responsible for the correct installation and
the commissioning.
The collector connections, even those of dry collectors, can become very hot
during the installation. Wear protective gloves as there is a risk of injury from
burns.
The following materials and tools are required for an easy and safe collector
installation:
1 x hammer
1 x tape measure
1 x pencil / chalk
2 x screwdriver / spanner SW 13
1 x wood drill approx. 5 mm (only roof integration)
1 x angle grinder with stone cutting disc
2 x open-ended spanner SW 30
1 x adjustable pliers
1 x hole saw (where the roof is already planked in)
Roof outlets for the solar lines (e.g. ventilation tile; cut to size with
an angle grinder)
Protective conduits (sensor lead, pipework)
Anti-falling protection
Crosshead bit
9
Advertisement
Table of Contents
