Installing The Camera - Omega 33746 Instruction Manual

INSTALLING THE CAMERA

The camera will come with the mount already attached. Flip the drone over and notice the clip
attachments on the bottom of the battery cover. The camera mount has two clips that snap into the
clip attachments.
Line up the camera with the mount to the clip attachments. The Camera lens should be facing the
front of the drone. If you don't know which way is the front, the side with the 2 red rotors is the front
of the drone. Push the camera with the mount toward the front until the 2 clips on the mount snap
into place.
CAMERA
WIRE
Once the camera with the mount is correctly
attached to the bottom of the drone, you will need
to connect the camera wire to the drone.
CAMERA
WIRE PORT
The camera wire port is located right next to the
battery cover.
If the camera wire isn't easily plugging into the
camera port then you may be installing it
backwards. Pull it out and flip it around and try
again.
Make sure the camera wire is fully plugged in.
To check if the camera is connected properly, turn
on the drone (power switch is located next to the
battery cover) and check to see if the LED lights
on the back of the camera are on. A blue and
green LED light should be blinking.
If the memory card is already installed, the LED
light will stay on blue.