I N TRODUCTION Thank you for purchasing this amazing World Tech Toys product. This drone is suitable for indoor and outdoor flight. Please carefully read the entire manual before operating this drone and keep it for reference in the future. SAFETY &...
GENERAL DRO NE PAR TS Propeller Blades (Rear) Battery Cover Propeller Blades (Front) Camera Landing Gear TRANSM ITTER SPECI FI CATI ONS Antenna NO FUNCTION Video Record Control Speed Control Flip Stunt Mode Easy Mode Photo Control Power Indicator Ascend/Descend Forward/Backward [Left/Right Turning] [Left/Right Sideways Flight]...
INSTALLING TRANSMITTER BATTERY First remove the screw on the CAUTION: battery cover and remove the 1. Make sure the polarity of the battery cover itself. Then batteries are correctly installed. install 4 AA batteries. Make Battery Cover 2. Do not mix old and new sure they are installed with the batteries.
Page 5
INSTALLING LANDING GEARS AND ROTOR GUARDS The drone comes with 2 types of screws. (A) Screw and (B) Screw. (A) Screw will be used for securing the 4 landing gears/legs to the bottom of the drone. (B) Screw is used to secure the 4 rotor guards to the drone(optional).
INSTALLING THE CAMERA The camera will come with the mount already attached. Flip the drone over and notice the clip attachments on the bottom of the battery cover. The camera mount has two clips that snap into the clip attachments. Line up the camera with the mount to the clip attachments.
USING THE CAMERA SD Card Installation: Insert the SD card into the slot, lightly press until the SD card clicks into place. Press the SD card to eject the card. The camera indicator WILL BLINK unless the SD card is properly inserted. Indicator Lights of Camera: •...
Page 8
FLYING THE DRONE Before flying the drone for the first time please read the instructions carefully and make sure you fully understand how to control your drone. BASIC FLYING CONTROLS Throttle Ascend Descend Move Forward/Backward Forward Backward Move Right/Move Left Move Left Move Right Left Spin/Right Spin...
AD J US T IN G T H E TR I M When drone moves with no directional transmitter input, adjust the trim controls until hovering is stable. If the drone is spinning to the left, push the RIGHT TRIM button until the drone stops spinning.
POST FLIGHT After you are done flying the Drone make sure the battery pack on the drone is disconnected and the transmitter power is turned off. If you are not going to use the drone for a long period of time, please remove the AA batteries to prevent the batteries from draining or leaking.