Installing Transmitter Battery - Omega 33746 Instruction Manual

INSTALLING TRANSMITTER BATTERY

First remove the screw on the
battery cover and remove the
battery cover itself. Then
install 4 AA batteries. Make
sure they are installed with the
correct polarity. Replace the
battery cover and screw in
place.
INSTALLING DRONE BATTERY
Locate the battery cover on underside
of drone. Slide open the battery
compartment in the direction shown.
CHARGING DRONE BATTERY
Switch off the power and slide
open the battery cover.
BATTERY PACK SPECIFICATIONS
Battery Type Battery Specification
Li-Po Battery 7.4V 850mAh
C AUT IO N W H IL E C H ARGIN G:
Do not charge with batteries still installed. Do not charge battery unsupervised. Do not immediately charge after
use. Do not overcharge battery. Ideal charge time is 200 minutes. Overcharging can cause a catastrophic
failure. Always charge on dry and ventilated areas away from any heat source or flammable materials. Always
use the original USB charging cable provided. Promptly change and replace old or defective batteries.
3
2
1
Insert Battery (1) and connect the red
plug on battery to the power port just
inside the battery compartment (2).
Close the battery cover and switch on
the drone (3).
1
2
Pull out the battery cable from the
drone's power port (1) and remove
the battery (2) before charging.
Usage Duration
Flight Duration 7 minutes
CAUTION:
1. Make sure the polarity of the
batteries are correctly installed.
Battery Cover
2. Do not mix old and new
batteries.
4 AA Batteries 3. Do not mix different types
(Not included.)
of batteries.
Push the left throttle joystick all the
way forward and then pull it all the
way back. A clear (Beep) will indicate
that your drone is now ready to fly!
Connect the batteries white
connector to the supplied wall
charger, connect to a power source.
The LED light on the wall charger
will be orange when charging and
will turn green when fully charged.
Charge for approximately 200
minutes for a full charge.
Charging Time 200 minutes
Charge Time