Preparation For Use - Echo CS-361P Instruction Manual

1a.
Unlock chain brake
CS-361P

PREPARATION FOR USE

1b.
Brake lever
(Front hand guard)
Two nuts
Clutch cover
Saw chain is sharp! Always wear gloves
when handling assembly, otherwise serious
personal injury may result.
KICK GUARD
INSTRUCTIONS
Tools Needed: Two 3/8 in. or 11 mm (7/16 in.)
Wrenches.
For saws with Kick Guard
Symmetrical Low-Kick type guide bars.
1a. Install 8-32 bolt in small hole of Kick Guard
and through small hole in guide bar.
1b. Install 1/4-27 bolt in large rear hole of Kick
®
Guard and through large front hole in guide
bar.
2. IMPORTANT: Dimple in Kick Guard
engage recess in guide bar (B).
3. Tighten nut (C) and bolt by hand until snug.
Make certain Kick Guard
bar.
4. Tighten nut additional 1/2 turn.
5. Check to make certain Kick Guard
guide bar.
GUIDE BAR AND SAW CHAIN
INSTALLATION/REMOVAL
NOTICE
• Move the chain brake lever (Front hand guard)
fully rearward to remove or install the clutch
cover to chain saw.
1. Remove spark plug lead.
2. Remove the clutch cover nuts and remove clutch
cover.
3. Remove bar and saw chain if necessary. See
"Maintenance and Care" section for guide bar/
saw chain maintenance procedures.
10
WARNING
®
TO BAR
®
P/N 2894902 and
®
(A) must
®
is flush against guide
®
is tight on
®