Dyson AM10 Operating Manual page 12

Once a month
(and before/after storage)
Turn the appliance into standby mode/'OFF'.
Unplug from the mains electricity supply.
12
1
Unclip the loop amplifier surround: pull from
the lower edge by hand, gently but firmly.
4
Empty the water tank. To release the water chimney, twist
the dial a quarter of a turn. Lift out. Clean thoroughly by
immersing in the citric acid solution for 15 minutes. Rinse and
wipe over all surfaces. Repeat if necessary. Refit in reverse
order, twisting the dial a quarter of a turn to secure.
7
Empty the trough of any water, small spillages may occur.
While not dangerous, care should be taken to avoid water
entering the inlets. Clean thoroughly, using the recommended
acid citric solution. Do not rinse under the tap or put in a
15 mins