Table of Contents
Advertisement
Do not use harsh abrasives, chemical cleaners or solvents to clean the exterior
of your iron because they will damage the surface.
Cleaning the Soleplate on your Iron
After each use, ensure the iron is switched off and unplugged from the mains supply
socket. Allow the iron to cool fully before wiping the soleplate with a damp soft cloth. If
polyester has burnt to the soleplate, iron a damp cotton cloth while hot. If necessary,
allow unit to cool fully and wipe over the soleplate with a soft cloth and a small amount of
methylated spirits. Remove the methylated spirit with a damp cloth. Ensure soleplate is
dried thoroughly.
Self-cleaning
Only press the self-clean button when you want to activate the self cleaning
system. Never press the self-clean button when ironing.
1. The self-clean function removes scale and impurities. Use the self-clean function
once every two weeks. If the water in your area is very hard, the self clean function
should be used more frequently.
2. Ensure the iron is switched off and unplugged from the mains supply socket.
3. Set the steam control to the no steam position (0).
4. Using the measuring cup, fill the iron with water to the MAX fill level.
5. Stand the iron on its heel rest, plug in and switch on at the mains supply.
6. Select the DENIM setting using the temperature select button.
7. Wait until the selected temperature has been reached (your iron will beep once, the
temperature indicator icon will stop flashing and the handle will light up red) then,
unplug the iron and hold it over a sink with the sole-plate facing downwards.
8. Press and hold the 'SELF CLEAN' button. Hot water and steam will be ejected from
the holes in the soleplate along with any impurities.
9. Release the 'SELF CLEAN' button after one minute or when the water tank is empty.
10. Stand the iron on its heel rest, plug into the supply and select DENIM. When your
iron has heated up, iron an old piece of cloth to allow any remaining water to escape.
11. After use, switch off and unplug the iron at the mains supply and allow to cool fully.
Empty any remaining water.
care and cleaning
11
Advertisement
Table of Contents
